Hello, i have a 2.4L 2004 wrangler and lately it has been difficult to get into a gear when completely stationary, i have to go to 3rd or 4th before going to 1st. it works just fine when its rolling. Also, if the vehicle is off it shifts into all gear just fine. This has me very confused because the car will roll on the slightest hill so i know the clutch is engaging , there is zero grinding so i wouldnt think it would be a syncro. Anyone have any advice? i allready replaced both master and slave cylinders ( not the line though ) it has been bleed properly and the clutch pedal has plenty of pressure and has alot of travel