I can do brakes/engine swaps have tools and am always willing to try anything once Iv seen it done but was asked to help a guy do this and am wondering if its hard? I of course I do front end work also.. thanks
so i just changed the diff in my 93 4runner, and the new diff came with the whole connector for the anti lock and a bit more wire. I couldnt get my connector apart due to some sorta tar so i cut it off after the connector so i could wire it back together.
question is, the truck is more of a project 4x4 and spends more time on the mountain then the road, do I really need the anti lock???
well, got the crank shaft spun bearing work handled and the motor seems to run fine. all's i had to do was file off the rough spot on the cap and block, and replace the bearing. I used lock tite to hold the bearing in place just to make sure it doesn't do it again. in all my years i've never heard of a main bearing spinning when the motor had proper oil pressure.
now however i have a new problem. NOT MOTOR RELATED. DURING THIS ENtire process the transmission had to be removed, obviously. when i pulled it,the tranny, it lost about 6 quarts of fluid.
The car is going to be a 98-00 civic si. I still haven't bought it yet, but I am planning the system in advance. I know all the electrical upgrades I will need, HO alternator, multiple runs of 0 gauge, extra batteries etc. For the 15" i would go with 1500 or 2500 series DD, as for the 18" i was looking at FI or RE audio. Before i think about the amps yet, I want to buy the subs so I know how much power i will be needing. If you have any advice or suggestions on what I should do let me know ^^ oh and i want to hit 150+ db.
Great Leap Forward / Cultural Revolution from 1949-1976.
40-50-million died under CCP: chinese communist party.
is this true?
is this just lies.
what's the real truth about mao zedong.. about china?
what is common box position installers use to get the most out of this kinda set up.
i have a ford explorer SUV with 4 15's in 2 separate sealed boxes.
should i fire both boxes to the rear or firing up or firing front.
there audiopipe txx apx 15's 1000rms/2000max each
powered by 2 AQ2200's
i know each position will sound different but what will be best and whats typical
i went sealed because i like how it sounds plus more space.